The 510 Realm

The frame is reinforced inside and underneath the body with steel tubing. So I can still open the Door even with a Samoan riding shotgun. As for being jealous No Im not. Just dont make it to hard just to lower your wagon, just get some blocks. Sometime people make it harder than it really is. If you...

yes the 720 front diffs will work but its a pain. Why waste your time witl all the Subarus around and the after market to support it. I have a 3.70 Sub LSD(150$) in my beater dual40mm mikuni equip car but car is now slower around town. best get a 3.90 or better a 4.11 LSD( i pay up to 300$) if I nee...

Just lower it with blocks and get some air shocks. Call it good. its still only a wagon. Just knock out or cut the rubber bumbs stops if it has them. Ill be OK. I like koni shocks myself(adjustable rebound only,the old ones). Most newer shocks like Tokico or KYBs(cheaper made) are gas and could slig...

A straight axle type is not going to fit the R160,R180 or R200s. They are totally different. Look under the car! Cant believe that one was asked. It would be closer to get a BMW 2002 rear end in there first than a striaght axle. get a Haynes manual first read it. Then get the How to rebuild you dats...

In the day they used to have offset NEW pistons,with pin holes which you could install longer L16 rods on L18s. So the piston does not come out the top of the bore. If you have a good crank and rods(L18) you can install it on a L16. But it wont be a L18 unless you over bore your L16 2mm over. Which ...

Dave carrol took my 510 struts and cut it to the 280zx struts (mine are koni). The 280zx is the shortest strut you can use datsun wise. But you have to cut the middle of the strut section out and reweld. This will give a shorter tube on the strut and you can install the supension teq spring with out...

Is the switch good at the pedal? There shouls be a round wire I believe by the license plate back side. For side marker lights You can buy new sockets at Schuck'd or where ever. Cut the rusted center off from the back side with a hack saw install the new center with epoxy or jb weld. Then solder the...

those wires he's looking for are for the relays that went up to the dual point distributor ,the horn, the washer pump, side marker lights.

Get a Haynes manual it has it all in there in the electrical diagrams.

Get a electronic dist or a conversion.

OK its added to the gallery with my pronounced name(heinz) Hainz is the way myold man spelled it(spelling Bee champion) Maybe it too flashy also but I bought it this way. It was a 4dr car built by Andy Aker in Renton Wash. 1982. Later was sold .took the top off. Eric Edward got it then i bought it s...

That was my 510. Personally it looks like Crap now.(IS that a spray can paint job) Red/wht/blku was the nissan racing colors. It helped in breaking up the Boxyness of that type of flare kit ( I should have used the other rounder IMSA box kit as on my yellow car) I dont know about flashy I guess. Wha...