The 510 Realm

Ok as of right now: 1) fuel injector 1 pulse signal is not recieving (probably why they called you on the harness) 2) MAF is shot and will need to be replaced (might as well get a new engine swap than buy this new) 3) VSS is not working correctly causing Limp 4) EGR is not recieving signal 1) Are y...

:D piece of cake...the rad comes with molded in mounting "tabs" for the elctric fan on both sides of the rad. I used some oe vw rubber washers for the lower mounting points,I measured the distance between the "dowels" transferred the the rad support once I had the proper spacing,...

If your in or near Vancouver call Andy at Specialty engineering...He knows his stuff.. he hooked me up with all my suspension, even modified my tokico inserts to work with my 240sx camber plates.

I'm sure you can find his number on the boards somewhere, if not I can dig it up for you.

the rad I chose is made by spectra premium I bought it from napa its part #cu75. It has a spin on rad cap, but no fitting for over flow tank and no drain cock.I saw Adam Corrola's car in Gras roots motorsport magazine with the fj-20 engine also using the vw rad, his rad cap had an overflow fitting b...

How many of you are running a vw radiator??

comments, Problems???

8) I got my "hero card" One of my mecanics was in Newfoundland for the targa and got to meet Bob. Being that all he ever gets to hear me talk about other than work is 510's He already knew about the"grasshopper"... I only wish I could've been there myself....Thanks for the card B...

The fuel lines are 5/16, pressure and return I figured if I ran same as stock on the 240 sx that I'd be ok... As for the trans mount I ordered it from keystone through my CTC for 39.99 the p/n is 31108r-0346454 the "r" in the p/n is for red... you need to reem out the holes on the mount ju...

What happenend with the "old" ka powered 510??

:D Thanxs for the offer... 8) Being that I run a 8 bay garage(and being a licensed tech as well) that consumes all my time ( and sanity) was that I don't have alot of time to dig around and search/cross reference p/n's All my spare time lately has been devoted to gettting the dime up and running... ...

just the info I was looking for...Thanks,

Dan

what were your readings... (HC CO NOx)??? I'm not sure what gases they look at in your neck of the woods... Failing for exessive CO may not necessarily mean that your running to rich... please let me know what the cutoff spec is (for your test) and what your results were...I'll be glad to give you a...

:D :D :D For the first time in almost 3 years my 510 is running again... What seemed to take forever... specialty engenering suspension front and rear... 280 zx struts/brakes all new brake and fuel line plumbing custom ka/sr 1" front bar 3/4"rear subie 3.70:1 LSD (soon to be 4.11:1) modifi...

I quickly looked into longer studs...you wouldn't happen to have the p/n for the arp studs wouldya'

as for the .5" spacers I imagine most "wheel" places would keep that in stock??

:) not to steal this thread....but I've been debating buying some wheel spacers (have zx struts) somebody clear this up... If I buy wheels with +24mm offset, will this clear my coil overs?? Now that my car is running(finally!!!) I need to put some wheels on it!!!!! I need suggestions....1000.00 cdn ...