The 510 Realm

Still looking for all the parts listed above i didnt make it out to the show so i need parts let me know if you have them for sale ....... thanks Robert (661)860-3593

Looks like it was a rad show.. im kicking myself in the ass for not going... i thought it was gonna rain so i didnt go... are there any other shows going on around here anytime soon?

What time does the show in Eaglerock start and end? What color and make is your car "hang510" so that i can find you and BS a little bit with you

Yea i have someone to watch my kid but i dont want to go if it rains haha does anyone know what the weather is suppose to do tomorrow

Im gonna try to get someone to watch my daughter if i get someone i will be there. Whats your buddys name whats he look like or what does his car look like so i can find him and buy the parts off of your buddy.. does he have a booth/area to sell stuff or is he just goin for the show?

Lookin to buy just a few missing peices for my 2dr 510... need; left front door handle gas pedal both front door armrests (nice condition) And headlight and wiper knob fon the dash If you have any or all of there parts give me a call or TEXT, IM etc preferably.. im located in Lancaster Ca. if you ar...

Ditto and qlso some of the basic thing like valve adjustmet tolerances, plug gaps etc. etc. that these cars like to run at

Sorry i posted the same thing twice

I dont have the valve cover off anymore i had it off to polish and paint it while i was waiting for brake parts and tire to get here but it can be removed again easly.. I put a new rubber cap on one of the un-used lines commin from the top of the intake manifold near the firewall, it apears to be a ...

I know reading up and learning all i can wont hurt at all.. but im just trying to eliminate everything i can ive heard everyones 2 cents about the carb and i was planning on doing that after i check the timing.. ive almost ruled out the carb since its cleaned new filter and fresh gas. I havent pulle...

Thanks for all the tip and starting points. I am mechanically inclined im not claiming to be a master tech but i do know how to turn a wrench..I know the car is old and im trying to find the reason why it hesitates (witch could most likely be a carb issue).. im not gonna completely tear down my moto...

Also.. shouldnt i see fuel comming out of the secondary? I hear the hissing/spitting vacume sound when the gas is applied (with the engine OFF) like mentioned by bert in his first reply.. how do i go about adjusting the float level? Bend it so it sits lower in the bowl??

From the looks of it, it looks to be an origional old distrib. With a new cap and rotor, and the timing is set right in the middle of retarded and advanced leaning just a hair towards retarded.. I have not tried to time it myself yet due to the fact i have no timing light... is there anywhere that i...

I know not to check it with a flame sorce haha. My buddy just got burn pretty bad by pouring gas down the carb and his dad starting the jeep when it was trying to start the carb back fired and starteled him and he shook the cup of gas into the air and on himself and got burn preety bad just a few we...

How would i go about checking if the accelerator is putting out between 3-3.5 like he said it should be set to? Also the odomiter only reads 136k and im not sure if its been rebuilt, replace or beet to crap by someone thinking it is a racecar