69 510 for parts **edited**

[karnutz]

I have a nearly complete 69 Datsun 510 4dr sdn for parts. Shell has papers. Parts are as follows.
-Backglass x3 $50 each
-Doors $75 each
-Rear control arms(with disk conversion) $50 each- sold
-Rear brake rotors(new) $25 each---- 300zx style- sold
-Rear crossmember $75- pending
-Rear differential(R180 with 411 gears) $100- sold
-Trunk lid $40
-Fiberglass fenders $60 each 2 lefts and 2 rights
-rear side markers- near mint condition. $140/pair
-Left front side marker NOS lens and chrome only $45
-Left front side marker used decent shape $15
Plus lots of small parts $10 and up
If I didn't list what you need e-mail me I probably have it.
No motor, trans, or front struts sorry.
I can e-mail pics. They are too big to add to this listing.
Prices are plus shipping.
Ok shell is no longer for sale. Going to cut it for parts.
I will have the following;
Radiator support no rust $150
New OEM end panel $250 (installed but no damage)
OEM left rocker panel with lower dogleg $150(installed but no damage)
Roof $100
Rear floor section(no rust) $75
Fuel filler neck(metal piece) $35
Gas door $25
Ignition with key $125
Gas door lock(no key) $5
Door locks(no key) $5 each
Trunk lock(no key) $10
Steering column(standard) $75
Steering box(no play) $100
Front crossmember $100
front lower control arms $25 each
Doorglasses $40 each
Rear door vent glass $25 each
Front seat risers $10 each
Rear seat complete no tears nice shape $100
Factory steering wheel in really nice shape $50
Hazard switch $25
Dash wiring harness(uncut) $50
Body harness(from dash to rear) $65
Rear side marker lights(69) $150
rear license plate lights $15 each
If you feel my prices are too high make me a reasonable offer. The worst I can say is no!

[RONSLYCHUK]

Hey Shawn, do you know what kind of shape the R 180 is in.If it is good I will take it. Also I still want to trade my RCA spacers for your one inch ones. Tanks in advance ! Ron.

[karnutz]

Gears are good. seals are decent. No problem on the rca's I still have some.

[butters68]

hey man, if you still have the rear crossmember ill take it.

[jason]

Is there a manual steering column shroud on that car? If there is, what kind of shape is it in? I'm looking for 2 right now.

[karnutz]

Column shroud is no good. Crossmember is there and good. Pm me for details.

[jason]

Dang thanks!

[butters68]

hey shawn, what about the heater box unit and stuff is that for sale too.? that would be nice for my car .

[karnutz]

It's all there but the car is a late 69 so has the 70 dash. Not sure if its the same or not.

[butters68]

dang i'm not sure about that. most likely not the same.

[karnutz]

bump to the top.Pulling it apart this week.

[karnutz]

If I don't have any bites on the shell by the end of the week I will be cutting it up for parts.
Prices are as follows;
-Rust free rad support with apron- $150.00
-Left rocker panel(installed but new OEM) with lower dogleg section $200.00
-OEM rear end panel(installed and body worked but will cut at seams) $295.00(last known price was $450)
-rear floor sections $50 each side(mint no rust)
-Complete roof section(no rust or damage) $150.00-(pick up only no shipping)

[ajen68510]

did u sell the rear control arms ?

[jason]

Ash tray?

[karnutz]

Yes control arms are sold. No ashtray.