The 510 Realm

Hey fellow Datsun fans,

I'm looking to purchase a set of rear door handles. I believe the 4-Door wagons and sedans are the same.

Thank you,

Joe

It's pretty easy to make new fronts work in the rear. Carefully grind out the pin holding the metal loop that hooks the latch. Then drill a hole, the right size in the right spot and install the pin and metal loop. You then have a nice new handle. Still available from Nissan.

Just resized a few pictures. Everyone likes pictures

Here are the part numbers for new from Nissan
80606-E4100
80605-E4100

Thanks Mike! Looks pretty straight forward. I do have a couple of 240z spare door handles. I’ll use those as a test run.

Though I’d still wouldn’t mind purchasing a set if anyone has a set or singles for sale.

I have a decent pair from my 2dr, if they'll work.

Where are you located?

Dean
gzentas510@outlook.com

Thanks Dean, I have the front door handles, just need a rear set.

Still looking...

Anyone have a rear set of door handles for a Datsun 510 they are willing to sell?

If you have the original rear handles the parts needed for the conversion can be pulled off them and installed on modified front handles.

FutoFab has front door handles for $34.95/pair +S&H.
Link - http://www.futofab.com/index.php?page=s ... &Itemid=81

They are aftermarket, but an excellent reproduction.

Here is a picture of the factory handle (top) with our reproduction handle below it.

Go with Futofab repop fronts and mod them to rears. Dave makes good quality at very reasonable prices.
Just My 2 cents

Pm