Anyone using nissan 14pin consult?

Engine, Transmission and related drivetrain.
Post Reply
User avatar
mell00510
Posts: 208
Joined: 21 Jul 2010 19:22
Location: Mn

Anyone using nissan 14pin consult?

Post by mell00510 » 13 Jun 2015 21:03

Looking for someone that runs a consult program on their ka/sr swap. (preferably a ka turbo, but begger's can't be choosers!) Using a laptop program such as ecutalk, conZult, ect. Just looking to have someone go and do 2 hard pulls and see if voltage drops at ecu, I'm chasing a gremlin out of my setup and can't find a local car to tap into myself to verify. See voltage dropping out topic for full story :lol:
datzenmike wrote:Too bad about the fire wall. What does the V8 weigh?

akara
Posts: 103
Joined: 19 Mar 2011 18:15
Location: San Diego, California
Contact:

Re: Anyone using nissan 14pin consult?

Post by akara » 14 Jun 2015 12:44

heres a log from my sr20det

Image
voltage starts off at 13.2 at idle and hits as low as 12.1 when full throttle in 2nd. dont think the alternator is charging at these rpms

User avatar
mell00510
Posts: 208
Joined: 21 Jul 2010 19:22
Location: Mn

Re: Anyone using nissan 14pin consult?

Post by mell00510 » 14 Jun 2015 13:20

Thank you very much, I have gotten out the piece of paper as suggested by Rob and will be using your input. (along w/ 3 other sources, including swapping a used alternator off the shelf into my car)
datzenmike wrote:Too bad about the fire wall. What does the V8 weigh?

Post Reply