Rear window latch issue

Paint, body preparation and modification, interior work and electrical
Button
Posts: 124
Joined: 25 Jun 2014 14:13
Location: Thousand Oaks, CA..

Rear window latch issue

Postby Button » 15 Oct 2016 14:53

Hey guys, I finally installed one of the rear windows on my 72 after painting it and replacing the rubber but when I go to latch it shut it doesn't "snap" closed and form a tight seal. I can press the latch down so it's almost tight but it springs back and stays in a loose state and would probably rattle if I was to drive it since it's not really closed. The hinges or pivots on all the latch joints are pretty sloppy, do I need to rebuild the latches or get new ones? Even with them being sloppy it still seems like they should snap in to their locked position.

I think I have them installed right. Is it a matter of adjustment of window height or anything? Anyone have any experience with this?

Thanks.

Chris

User avatar
MikeY
Posts: 358
Joined: 26 Jun 2003 16:25
Location: Qualicum Van Isle

Re: Rear window latch issue

Postby MikeY » 15 Oct 2016 15:47

Fwiw. I just installed new latches on a car I've restored. I hadn't owned a 2 dr in years. I reused the old rubbers but when I went to try and close the window it didn't seem to want to snap closed. I was afraid I was going to break something. But I finally pushed it harder than I wanted too and it snapped closed. That's where I'm leaving it. The car is for my son and I told him the latch was decorative and to leave it closed. As a kid with a 2 dr I remember driving with them open and having the window bouncing around was an easy way to break a latch. So maybe just push a little bit harder.


Return to “Body & Electrical”



Who is online

Users browsing this forum: Baidu [Spider], Bing [Bot] and 2 guests