WANTED to Buy - 510 Brake Master Cylinder

[qwik510]

Wanted to Buy!
Datsun 510 Brake Master Cylinder
3/4” Bore size
Tokico or Nabco.
Prefer New NOS or very clean and working condition used.

[yenpit]

Hey dood! If it comes down to it, I've got plenty of good CORES, might even have an NOS rebuild kit............let me know!

TJ

[qwik510]

Hey dood! If it comes down to it, I've got plenty of good CORES, might even have an NOS rebuild kit............let me know!

TJ

Thanks TJ!

I located a few from other 510 guys. I have one one the way from a guy in Texas. He was reasonable about the price. Just a bit more then what an aftermarket one would cost.

I’m going to rebuild the original and keep it for a spare.

[Three B's Racing]

Hey dood! If it comes down to it, I've got plenty of good CORES, might even have an NOS rebuild kit............let me know!

TJ

Thanks TJ!

I located a few from other 510 guys. I have one one the way from a guy in Texas. He was reasonable about the price. Just a bit more then what an aftermarket one would cost.

I’m going to rebuild the original and keep it for a spare.

Hey Dave, make sure you inspect the bore of the master for pitting, rust and contaminants. Sometime you need to hone those things with a honing tool for the 3/4" size. Every master that I've rebuilt I've gone ahead and honed the bore wether it needed it or not just for the fresh surface for the new seal to work with.

[yenpit]

Agree with Lou ^^^^^^^ ..............hone no matter what!

TJ

[datzenmike]

I took my 'new' clutch slave apart to be sure there was no machining debris. Wet it with brake fluid so the seal wouldn't be dry the first time it was used.