Question on a couple pieces

[Rush]

Hey guys, since so many of you know every square inch of our 510's can you help me out? Can someone tell me the size of the little ball(s) on the throttle linkage assembly? I'm modeling a set for 3D printing since mine have definitely seen better days. I need to know the ball size so I can make the proper joint & I'd rather not destroy mine in the process just in case the print doesn't come out well for some reason.

Also, what size nut goes on the lower control arm (where the odd "keyed" washer is)?






Thanks!

[iceman510]

I measured one at 8mm. It might be a Z lever though, not a 510. Still looking for that one. I'll update if I find it.

[Three B's Racing]

You know, you can pop the levers off the ball's and reattach them.