new member

Users must be approved by our moderation team before posting in other forums.
Post Reply
Legoman27
Posts: 27
Joined: 19 Nov 2023 20:21
Location: Virginia

new member

Post by Legoman27 »

Hi all,
I've had my 71' wagon for a few years but recently have started to get a little deeper into the project
spent a long time working to 3d print a new hinge cover when I was separated from the car
currently in the midst of replacing the rockers and cleaning up floor pans
recently picked up an L20B so I'm hoping to find some good info on the swap here
Attachments
3 d printed vs original hinge cover
3 d printed vs original hinge cover
hinge cover.png (680.29 KiB) Viewed 483 times
this is right after I finished replacing the driver's side rocker
this is right after I finished replacing the driver's side rocker
PXL_20231008_191035256~2.jpg (637.13 KiB) Viewed 483 times
Post Reply